Of maintenance or other upstream equipment issue.ĭata - signifies data flowing through the ONT to the gateway.īlinking Yellow (?) - speeds 100Mbps (i.e. The factory alarm will have a siren and your car will beep when locking/unlocking. If the Alarm and Ready lights are flashing it indicates a Paper Jam or No Paper. Reload paper in the Rear Tray or Cassette and press the RESUME / CANCEL button on the printer. The clown nose is supposed to blink only with factory alarm installed. Two (2) flashes: Printer is out of paper. If your detector or alarm has a blinking or steady light with no audible alarm sound, this typically indicates that the unit is receiving power. The signal intensity is measured in DB, and it is either out of specified range, or non-existent.Ĭould be broken fiber, a fiber to fiber splice that is poor, or no signal from the street because Re: Question on alarm system - red light below mirror supposed to blink Most of the BMWs here do not come with factory alarm system. Ultra-bright warning light with various flash patterns and ability to set multiple units in simultaneous or alternating operation for indoor or outdoor. Solid Green - Service is on - unit is receiving data from the network.Īlarm - If on, indicates issue with the fiber connection from the street to the ONT. Possible cut in the fiber / tree limb, or equipment upstream of you not getting proper power. Seems like you have no service to the house.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |